Project Rex

Post by **Ben** » Mon Jul 15, 2013 7:26 pm

unreal!! ....

RX7 · Post by **RX7** » Mon Jul 15, 2013 7:46 pm

Bonkers mate and well done in removing !! Pita doing that job

Mad the amount of damage though.

Gedge · Post by **Gedge** » Mon Jul 15, 2013 8:14 pm

Yeah thanks for the wise words dude. Another 7 hours putting it all back together again!!

gary@apt · Post by **gary@apt** » Mon Jul 15, 2013 9:08 pm

so any idea where ends of blades have gone?

RX7 · Post by **RX7** » Mon Jul 15, 2013 9:13 pm

Probably into the engine causing the tip failure before he had it rebuild I would guess. Would have heard it if they were still in there now.
Remember that scene in Jaws where Quint drags his fingernails down the blackboard

Post by **Stuart** » Mon Jul 15, 2013 9:43 pm

Like

Post by **Ben** » Mon Jul 15, 2013 9:48 pm

RX7 wrote:Probably into the engine causing the tip failure before he had it rebuild I would guess. Would have heard it if they were still in there now.
Remember that scene in Jaws where Quint drags his fingernails down the blackboard

pmsl ..very good G

Gedge · Post by **Gedge** » Mon Jul 15, 2013 10:07 pm

RX7 wrote:Probably into the engine causing the tip failure before he had it rebuild I would guess. Would have heard it if they were still in there now.
Remember that scene in Jaws where Quint drags his fingernails down the blackboard

This

Bit miffed that my builder didn't spot that though!! He couldn't have taken the rear intake pipe off

gary@apt · Post by **gary@apt** » Tue Jul 16, 2013 6:42 am

its worth blowing intercooler in reverse just incase any of big bits stuck in there

RX7 · Post by **RX7** » Tue Jul 16, 2013 6:48 am

gary@apt wrote:its worth blowing intercooler in reverse just incase any of big bits stuck in there

It's a good shout mate.
Not sure if he changed his intercooler since the rebuild though but deffo worth a check !!

Is this the start of Gary working on RX7s