help fitting apexi avcr boost controller into pulsar

Tk · Post by Tk » Tue Mar 03, 2009 7:09 pm

anyone had any experiance fitting an avcr , im useless with instructions :lol: and knowing me will do something stoopid and frazzle it
beer tokens on offer for assistance
it all looks ok and straight forward until i got to the splicing into the ecu wires :?

blacky · Post by **blacky** » Tue Mar 03, 2009 7:32 pm

Is there no topic on Pulsar lovers.com to help you Trev??

Gerry H · Post by **Gerry H** » Tue Mar 03, 2009 7:46 pm

If you have the ecu pin-out diagram, it should be quite straightforward. Just make sure you get the right colour wire, from the AVC-R loom spliced into the correct ecu plug wire.

I don't think you can do anything catastrophic as you're only picking up the sensors signals for display, not putting anything into the ecu. the AVC-R outputs are direct to the solenoid valve.

Suppose you could cheat and use those bulky caravan connectors (can't think of the name but the side by side splicing thingys)

But do make solder joints to finish off

BTW, make sure you fit a scramble button for a little oomph on the low setting

rayman gtir · Post by **rayman gtir** » Tue Mar 03, 2009 8:14 pm

trev i could give you a hand, but wont be till the weekend, there is a pic of the ecu pinouts on the owners club.

http://www.gtiroc.com/forums/showthread ... uts&page=2

Tk · Post by Tk » Tue Mar 03, 2009 8:53 pm

i have the apexi manual with diagrams etc.. so should not be to hard
all i need is some hose
i might take you up on the offer dave im sure between us we can do it

next job will be worn trackrod end , osf wheel has a little side to side movement

jamie@gbh · Post by **jamie@gbh** » Tue Mar 03, 2009 9:51 pm

i don't mind lending a hand Trev, i'm only round the corner!