APT Evo- Geartronics Paddleshift up and running, with dyno footage :)

James Breadvan · Post by **James Breadvan** » Wed Feb 25, 2009 10:29 pm

So after spending all that money on the car have you managed to get the digital clock to work properly!

gary@apt · Post by **gary@apt** » Thu Feb 26, 2009 8:18 am

dunc,yeah its very secure as lower splitter has a big flat surface underneath but yes i have braces

its work in progress fitting in as an when with work being so busy

james yeah still using clock as engine run time! :-D

gary@apt · Post by **gary@apt** » Mon Mar 09, 2009 8:12 pm

thought id add a few pics of latest bits we done

some better front end aero....

so off to mlr 30-130 were we managed a time of 8.9 on esso super unleaded and 8.35 on race fuel

blacky · Post by **blacky** » Mon Mar 09, 2009 9:58 pm

Looks proper now Gary 8)

duncan · Post by **duncan** » Mon Mar 09, 2009 10:23 pm

Nice to see a proper rear spoiler too (sort of

)

pablo · Post by **pablo** » Tue Mar 10, 2009 5:12 am

One thing would really finish that off nicely...............If it was parked on my drive :lol: :lol: :-D .

RX7 · Post by **RX7** » Tue Mar 10, 2009 7:26 am

Looks like a serious race car now Gary !!!

gary@apt · Post by **gary@apt** » Sat May 30, 2009 5:22 pm

bit of update, the evos been off road for a while for a few reasons

mainly cause we been so busy not had a chance to do much but also that with all oil pump failures i wanted to give engine a refresh rather than ending up with a big engine failure.

so its been out and had a hone with new set of rings,new main bearings etc and refaced head and block as it used to lift head with thick gasket so have machined pistons back down to use a stock evo mr gasket

pace have sent me a redesigned dry sump pump bracket to gain me some more room around exhaust which i filled with one of ross's turbo kits, this time im trying a t04z like what jason runs on his gtr

this should see me at 700bhp on pump fuel hopefully with more on race fuel and may be a shot of NOS

will get some pics asap....

Post by **Stuart** » Sat May 30, 2009 7:36 pm

Shite!!

Like you need more power :lol:

So when is this getting christened?

gary@apt · Post by **gary@apt** » Sat May 30, 2009 8:11 pm

soon i hope mate im just waiting on head and a few other bits