Clutch aligning tool

IWANT1 · Post by **IWANT1** » Mon Mar 17, 2008 8:59 pm

Iam not sure how others in the range are constructed but ive gone for the comp-R. I assumed that the two plates would have had individual splines that you would have to line up with each other but each plate sits around one shaft so i only need to line it with the spigot/flywheel.

Gerry H · Post by **Gerry H** » Mon Mar 17, 2008 9:33 pm

Different to mine then. Not sure what model it is.

Good luck, sounds horrendous.

IWANT1 · Post by **IWANT1** » Thu Apr 24, 2008 6:29 pm

Starting the change tomorrow and it seems like i might need a slide hammer does anyone have one that is localish??
Thanks in advance...

lee

Mr Fletcher · Post by **Mr Fletcher** » Thu Apr 24, 2008 6:35 pm

i had one i will have a look in the morning to see if i still have or if it is on loan somewhere :roll:

what end do you require on it :?:

also lee how long is the ax :?:

cheers

jason

IWANT1 · Post by **IWANT1** » Thu Apr 24, 2008 7:11 pm

13 mm thread i believe

:-D

Will have a measure up but its only a little one :?:

:?:

Cheers

Mr Fletcher · Post by **Mr Fletcher** » Thu Apr 24, 2008 7:31 pm

i was wondering if the ax would fit on my lorry with my bmw if you where struggling to get it to the autotest

cheers

jason

Post by **Stuart** » Thu Apr 24, 2008 7:47 pm

Now there's a plan

The time will come when we have our own car transporter with 8 race cars on it :lol:

Mr Fletcher · Post by **Mr Fletcher** » Thu Apr 24, 2008 7:52 pm

now that would be a site to see stu 8)

cheers

jason

IWANT1 · Post by **IWANT1** » Thu Apr 24, 2008 8:02 pm

Google says 3531 mm 139 in . :lol:

That would be great ive now passed my towing test but with all my vehicles i dont have one capable of towing and dads seen me drive to often so isnt that happy to let me use the ML. :-({|=

Mr Fletcher · Post by **Mr Fletcher** » Thu Apr 24, 2008 8:15 pm

i'll check this all out in the morning and pm or phone you either way.

cheers

jason