STi Time Attack 2008 - new dyno figures !!

Post by **Ben** » Sun Dec 30, 2007 10:07 am

:-D oow, sounds brillant mate - can't wait for a ride when this beauty is done.

gary@apt · Post by **gary@apt** » Sun Dec 30, 2007 10:08 am

dunc my advice for a clutch would be a twin plate,any thing single plate just wont last

Post by **Ben** » Sun Dec 30, 2007 10:11 am

then why not go triple and make it future proof ..

gary@apt · Post by **gary@apt** » Sun Dec 30, 2007 10:15 am

ben my triple is 2.2k's and each plate is

Post by **Ben** » Sun Dec 30, 2007 10:17 am

chaaa .. it's only money

... fair point .. but you broke a twin.

pablo · Post by **pablo** » Sun Dec 30, 2007 11:47 am

Duncan that spec is going to be awesome. Good luck to you with the build

Gerry H · Post by **Gerry H** » Sun Dec 30, 2007 12:13 pm

Nice spec Dunk should be a flier when it's done

Will you be revealing who is doing the work and how much?

Exedy twin plate cost me

duncan · Post by **duncan** » Sun Dec 30, 2007 12:56 pm

[quote="Gerry H"]Nice spec Dunk should be a flier when it's done

Will you be revealing who is doing the work and how much?

Exedy twin plate cost me

ScoobieWRX · Post by **ScoobieWRX** » Sun Dec 30, 2007 3:30 pm

Duncan.....Is your gearbox strong enough to take the strain?

All well and good having a top clutch that can handle shedloads of power but there is only so much torque the gearbox can handle before it lets go.

I know the clutch is there as a safety measure so that goes before the gearboc does (normally) but surely if you had a super strong clutch the gearbox is then in danger of copping it.

I hear PPG do some really good full Synchromesh gears/shafts for the Scooby box.

http://www.ppgearbox.com.au/products.htm#1

duncan · Post by **duncan** » Sun Dec 30, 2007 4:08 pm

ScoobieWRX wrote:Duncan.....Is your gearbox strong enough to take the strain?

All well and good having a top clutch that can handle shedloads of power but there is only so much torque the gearbox can handle before it lets go.

I know the clutch is there as a safety measure so that goes before the gearboc does (normally) but surely if you had a super strong clutch the gearbox is then in danger of copping it.

I hear PPG do some really good full Synchromesh gears/shafts for the Scooby box.

http://www.ppgearbox.com.au/products.htm#1

The 6 speed gearbox is good for well over 500 so should be fine on that.