BNR32: Project NUR (with dyno graphs)

mirage · Post by **mirage** » Fri Dec 07, 2007 7:25 pm

here are the pipes all heat wrapped and ready to go, i used thermo tec gen 2 coppermix wrap on these and ill use the tomei stuff on the downpipes.

tomei sump baffle plates also here now

mirage · Post by **mirage** » Sat Dec 08, 2007 5:11 pm

what heat grade plugs do you think ill need for this setup 7's or 8's?

323ian · Post by **323ian** » Sun Dec 09, 2007 12:01 pm

Depends on what level of boost you will be running.

mirage · Post by **mirage** » Sun Dec 09, 2007 1:13 pm

.8 or .9 until new turbos

mirage · Post by **mirage** » Sun Mar 02, 2008 5:54 pm

few more bits i got on saturday, i only ned the downpipes and PFC now!!!!

the things in the bubble wrap are knock sensors

its nearly there

Post by **Ben** » Sun Mar 02, 2008 9:47 pm

Looking good

mirage · Post by **mirage** » Thu Mar 06, 2008 6:37 pm

ive finally managed to get it booked in for monday the 7th of april, so im counting down the days now!!

just need to get a PFC not sure which type im going for yet tho, and im also getting 2 new o2 sensors from nissan which unfortunatly cost

Post by **Ben** » Thu Mar 06, 2008 8:52 pm

Going to be mighty fine when it's done - for reference Chris at H-tech is getting to be a dab hand at R32 rear arches

mirage · Post by **mirage** » Thu Mar 06, 2008 9:48 pm

yeh i was planning on going there for everything

Post by **Stuart** » Fri Mar 07, 2008 11:44 am

Sounds great John and the thoughts of having your car back on the road after all of this time must be tantalising

For God's sake, get Gary to fit a rev limiter to it this time.