offside front caliper S14a

Need something? ...ask here.
Post Reply
Hugh Janus
Posts: 192
Joined: Mon Nov 20, 2006 6:41 pm
Location: Wickford Essex

offside front caliper S14a

Post by Hugh Janus »

as above, mine is causing real problems

gary@apt
Posts: 1527
Joined: Thu Jul 27, 2006 7:04 pm
Location: norwich
Contact:

Post by gary@apt »

hugh,can you not take it back to monkeys who did it before :lol:
Image
EVO 7 with 2300cc,GT35,HKS 272's,1000cc,MOTEC...the list goes on..

Hugh Janus
Posts: 192
Joined: Mon Nov 20, 2006 6:41 pm
Location: Wickford Essex

Post by Hugh Janus »

gary@apt wrote:hugh,can you not take it back to monkeys who did it before :lol:
lol very funny :x :P 8)

gary@apt
Posts: 1527
Joined: Thu Jul 27, 2006 7:04 pm
Location: norwich
Contact:

Post by gary@apt »

lol
laughing aside can you not get a seal kit for it?

do you know if pistons are rusty?
Image
EVO 7 with 2300cc,GT35,HKS 272's,1000cc,MOTEC...the list goes on..

Hugh Janus
Posts: 192
Joined: Mon Nov 20, 2006 6:41 pm
Location: Wickford Essex

Post by Hugh Janus »

gary@apt wrote:lol
laughing aside can you not get a seal kit for it?

do you know if pistons are rusty?
i think that's what it needs, if i use the brakes too heavily (even just once) they then start to bite constantly even to the point where actually pulling away from a a set of lights for instance is a real struggle and when travelling at about 70 earlier the whole car was shaking, i pulled over sat in a layby for about 2 mins by that time they had released and was able to drive normally, i pretty sure i have also warped the disk too

gary@apt
Posts: 1527
Joined: Thu Jul 27, 2006 7:04 pm
Location: norwich
Contact:

Post by gary@apt »

you can get a overhaul kit from nissan thats easy,then a new set of discs and pads

this is a prob you had for a while mate

get it done properly....
Image
EVO 7 with 2300cc,GT35,HKS 272's,1000cc,MOTEC...the list goes on..

Hugh Janus
Posts: 192
Joined: Mon Nov 20, 2006 6:41 pm
Location: Wickford Essex

Post by Hugh Janus »

gary@apt wrote:you can get a overhaul kit from nissan thats easy,then a new set of discs and pads

this is a prob you had for a while mate

get it done properly....

amen to that, i suppose the car doesnt really get used too much so that may not help either, cheers Gary

V8_EATR
Posts: 815
Joined: Wed Apr 11, 2007 11:19 pm
Location: Los Angeles, CA

Post by V8_EATR »

Send 'James s' a pm as I fancy his front 8 pot set up :-D

Post Reply