Gareth's Induction Shield Request

RX7 · Post by **RX7** » Sun Jun 17, 2007 7:41 am

Let me know if you are able to get some Dunk as I am after some for induction shielding.

RX7 · Post by **RX7** » Sun Jun 17, 2007 3:36 pm

I will get my measurements drawn up and put through a request to you Fast Eddy. Gonna be a while yet though.

Cheers

Fast Eddy · Post by **Fast Eddy** » Sun Jun 17, 2007 9:11 pm

No worries Gareth,
I make my own range of universal heat sheilds for K&N type filters and make specials too, but if you just want material that is fine. I keep a stock of blanks that may do the job anyway.
Eddy

RX7 · Post by **RX7** » Sun Jun 17, 2007 9:59 pm

Fast Eddy wrote:No worries Gareth,
I make my own range of universal heat sheilds for K&N type filters and make specials too, but if you just want material that is fine. I keep a stock of blanks that may do the job anyway.
Eddy

I have the HKS RS induction kit with the 2 cones, what I am after is firstly a piece of alu to block the radiator situated directly below the cones and then maybe some shielding from the back of the induction pipes.

But good to know, I will get the measurements made up....they have to fit with the vented bonnet I am putting on shortly you see.

duncan · Post by **duncan** » Mon Jun 18, 2007 5:48 am

Split away into its own thread