Where to get methonol for a water meth kit??

dee_rz · Post by **dee_rz** » Tue Apr 03, 2007 8:20 pm

Yes as above where can i get methonol from for a water meth kit?? I've heard about the screen wash rumor but can't say i'm kean on that :? it's for a kit that sprays the meth/water direct onto the fmic.

Cheers in advance 8)

sdminus · Post by **sdminus** » Tue Apr 03, 2007 8:29 pm

Dont use screen wash... how much do you want ?
Be carefull spraying meth near hot engine parts. It burns with a colourless flame and can make you blind as well as dead LOL

Scott

dee_rz · Post by **dee_rz** » Tue Apr 03, 2007 8:44 pm

It will be a very diluted mix so i'm told or been advised not pure meth and i will be using solely for cooling and not gaining more power (well i may change my mind :twisted: )
Thanks for that though

It will be going in a 2.2 litre tank and don't have any idea how much i'll need though as it will depend on how much i use it, the 2.2 litre tank will supply enough spray for a constant 6 mins full out continual.

dee_rz · Post by **dee_rz** » Tue Apr 03, 2007 8:47 pm

Wasn't going to use the screen wash

didn't like that idea atall.

The kit comes with a control box and can be set on rev curves etc or manually 8) also has warning light etc for low level which is good if i do use it for tuning benefits.

sdminus · Post by **sdminus** » Tue Apr 03, 2007 8:54 pm

Cool I can get any amount you want. How does 5 gallons sound ?

Call me or text me tomorrow and i will sort you a price. This is M3 methanol so the very daddy of the stuff

As borat says.... I get you good price yes........

Scott

martin · Post by **martin** » Tue Apr 03, 2007 9:25 pm

kellers model shop in norwich does it neat :-D

dee_rz · Post by **dee_rz** » Tue Apr 03, 2007 10:26 pm

sdminus wrote:Cool I can get any amount you want. How does 5 gallons sound ?

Call me or text me tomorrow and i will sort you a price. This is M3 methanol so the very daddy of the stuff

As borat says.... I get you good price yes........

Scott

:thumb:

that is very nice

cheers for the pm

duncan · Post by **duncan** » Wed Apr 04, 2007 6:29 am

What benefit will spraying methanol onto a fmic have?

I was led to believe that the latent heat removal through evaporation is greatest with water.

sdminus · Post by **sdminus** » Wed Apr 04, 2007 6:48 am

Methanol has a faster evaporation. It will evaporate when it is sprayed on a surface over 11 deg C. But it is corrosive to aluminum.

methanol 472 BTU per lb but will evaporate at a low temp. Once it changes state. from a liquid it can not return

water 972 BTU per lb Can and will return to liquid again. Has a low air saturation point

Scott

martin · Post by **martin** » Wed Apr 04, 2007 8:25 am

dynamix wrote:What benefit will spraying methanol onto a fmic have?

I was led to believe that the latent heat removal through evaporation is greatest with water.

If you want something to spray onto an intercooler you want to get some of the stuf plumbers use to freeze water in the pipes so they can then cut and cap the pipe. I will be getting some for the next pod run ill give my intercooler a good spray of it just befor i run should be nice and cold charge temps then 8)