Custom Brake Ducting made ??

duncan · Post by **duncan** » Thu Jan 04, 2007 3:32 pm

I am wanting to run some ducting to my brake calipers to help cool them down and need some custom air ducts made that will fit into a limited space.

Is there anyone here that can either make these or point me in the right direction.

The ducts will need to be cut into the bottom edge of my front splitter lip and be curved to fit this.

Any advice welcome.

I cant use the existing fog light surrounds as this is being used for induction kit.

323ian · Post by **323ian** » Thu Jan 04, 2007 5:23 pm

Demon tweeks sell the special stuff for this.

On my old Mazda i made some up from flexible tubing i found on a building site.

Just needs a bit of flexible tubing and some ingenuity mate!

"MADDOG" · Post by **"MADDOG"** » Thu Jan 04, 2007 6:59 pm

I will also be very interested

regards "MADDOG" :thumb:

frayz · Post by **frayz** » Fri Jan 05, 2007 1:14 am

I'll be following this too Dunc

Pike · Post by **Pike** » Fri Jan 05, 2007 8:48 am

What diameter ducting are you looking for Duncan? I've got some old cooling ducting floating around if its any help.

duncan · Post by **duncan** » Fri Jan 05, 2007 9:05 am

I have the ducting sorted - need the intakes really.

Like the highlighted bit here:

Pike · Post by **Pike** » Fri Jan 05, 2007 9:20 am

Sorry I was lazy and didn't read the thread! :oops: