Am i nuts.. JDM Spec C roof vent?

duncan · Post by **duncan** » Tue Dec 26, 2006 2:00 pm

Go for it

shooter · Post by **shooter** » Tue Dec 26, 2006 2:06 pm

Yep def go for it, they are a lot easier to do than you think, once measured and measured again to make sure everything is in the right place its a simple job. If using a dremmel then I'd say you can leave the headlining in place, if a jigsaw then I'd think about dropping the front part of headlining to make sure you don't make a mistake.

Also once you have marked out your cut line, work inside it forst to remove most of the area, then go back and trim to the line, unless you are confident on sticking to the line.

frayz · Post by **frayz** » Tue Dec 26, 2006 3:44 pm

Done many of these then Shooter?

roey · Post by **roey** » Tue Dec 26, 2006 9:34 pm

i have a petrol angle grinder if you want to borrow it lol :lol:

frayz · Post by **frayz** » Tue Dec 26, 2006 9:57 pm

roey wrote:i have a petrol angle grinder if you want to borrow it lol :lol:

With friends like you lot... :roll:

roey · Post by **roey** » Tue Dec 26, 2006 10:30 pm

only kiding mate will look awsome go for it

shooter · Post by **shooter** » Tue Dec 26, 2006 10:40 pm

Not done a scooby roof vent but loads of sunroofs, vents and body mods in my time, even been known to attack motors with a dremmel or two as some on here can testify :P

If you need help etc just shout.

323ian · Post by **323ian** » Tue Dec 26, 2006 11:28 pm

You brave man!
Top marks for the balls of steel!

frayz · Post by **frayz** » Wed Dec 27, 2006 10:43 am

Cheers for that Shooter.. but i think im gonna brave this one alone, just for my own satisfaction

I'll be sure to post my own pics when I do it

rayman gtir · Post by **rayman gtir** » Wed Dec 27, 2006 10:53 am

i think it would look graet, but i dont think i would have the balls to do it. good luck.