My Nissan Silvia S15

Mr Fletcher · Post by **Mr Fletcher** » Mon Feb 20, 2012 7:50 pm

had mine skimmed on the bmw on the car ,transformed them and ferrodo pads didn't suit me but thats another debate on its own:)

drifter · Post by **drifter** » Mon Feb 20, 2012 7:50 pm

200jimcone wrote:Is the one your removing the same as Nash s ?

Yep

drifter · Post by **drifter** » Mon Feb 20, 2012 7:52 pm

Mr Fletcher wrote:had mine skimmed on the bmw on the car ,transformed them and ferrodo pads didn't suit me but thats another debate on its own:)

I'm pretty sure it will do the job

I might have to change the pads as Gary did mention the DS2500's can cause a problem. For the time being I'll stick with them until I plan some track time

200jimcone · Post by **200jimcone** » Mon Feb 20, 2012 7:52 pm

Ok cool best I get polishing. I wanna ride in the a15 once it's mapped and all sorted

BenTaylor · Post by **BenTaylor** » Thu Feb 23, 2012 3:24 pm

Hope the plenum sorts things out

drifter · Post by **drifter** » Thu Feb 23, 2012 3:35 pm

BenTaylor wrote:Hope the plenum sorts things out

Same here mate

I can't see any other reason why it would be struggling to take the timing it should be. I'll chuck in a new set of plugs although I can't see that being an issue. Only other things that I have thought of are an ECU/sensor issue which I'm sure Gary would have noticed, or I dropped a bolt in it without knowing

It's going on the ramps again tomorrow to check the disks with a dial gauge as well, plus to check I haven't left anything loose that might be causing the wheel wobble

drifter · Post by **drifter** » Sun Mar 04, 2012 12:44 pm

New plenum is on along with the fuel rail using new brackets

Just need to get this lot welded together to finish the IC pipe and it's ready for round 2

Last thing to go is a set of Tomei adjustable cam sprockets which are on the way from RHDJapan. Gary can fit those, I can't be trusted with something that critical

gary@apt · Post by **gary@apt** » Sun Mar 04, 2012 7:03 pm

good stuff mate

haha vavles meet mr piston

drifter · Post by **drifter** » Mon Mar 05, 2012 8:17 pm

Please Mr Gary sir, can I have another one of those ally fittings please

It was all going so well, all done except the threaded part and the last little bit just won't weld, just keeps going scabby

With the continued attempts it's got hot enough to fuck the thread as well

Bloody annoying as I'd hoped to get it all done and dusted today, but it all needs doing again, new piece of pipe on the way from ebay.

drifter · Post by **drifter** » Fri Mar 09, 2012 1:40 pm

Fucking ParcelForce, 1 day to travel 6000miles from Japan to the UK, then 5 days to have a piece of paper stamped before it can be processed