Milltek exhaust opinions please

duncan · Post by **duncan** » Tue Dec 23, 2008 10:29 pm

That's a 2.5 inch system - the 3 inch Milltek is much better flowing.

Jim1987 · Post by **Jim1987** » Tue Dec 23, 2008 10:34 pm

thats whats on mine duncan, milltek 3'' downpipe

boost targets today showed that i'd say

IWANT1 · Post by **IWANT1** » Tue Dec 23, 2008 10:40 pm

Shame as bloody cheap.

ginger ninja · Post by **ginger ninja** » Tue Dec 23, 2008 11:01 pm

Found this Magnex one, bloomin cheap: http://cgi.ebay.co.uk/SUBARU-IMPREZA-EX ... dZViewItem

IWANT1 · Post by **IWANT1** » Tue Dec 23, 2008 11:16 pm

Have a magnex on mine only problem ive had is one hanger is a tad short and when launching it used to jump of but soon sorted with jubilee clip.
Seems like lots of section/pieces making that system but mainly flangeless joints that will improve flow.

duncan · Post by **duncan** » Wed Dec 24, 2008 7:39 am

[quote="ginger ninja"]Found this Magnex one, bloomin cheap: http://cgi.ebay.co.uk/SUBARU-IMPREZA-EX ... dZViewItem

ginger ninja · Post by **ginger ninja** » Wed Dec 24, 2008 10:55 am

Thanks for that, I was a little concerned with all those joints on the magnex system,
I also didnt realise that they had gone under aswell, crikey they have been going for years.

[quote="duncan"]Hold fire for the moment on the exhaust - I may have a plan ]

ok mate will do

Rob S · Post by **Rob S** » Wed Dec 24, 2008 5:51 pm

Can you not get a stainless system built for that?
Hayward and Scott spring to mind....