Carbon Sheeting - SOLD

Ian (DaOne) · Post by **Ian (DaOne)** » Thu Jan 17, 2008 5:19 pm

is this bendy, or stiff? would like to make a exhaust heat shield for the tail pipe, so would only need a little bit.

but would it be easy to bend into a angle and for it to stay there?

any info welcome

thanks
ian

duncan · Post by **duncan** » Thu Jan 17, 2008 5:21 pm

Not bendy Ian. A big sheet will bend a little but it would not form an angle of any shape just a very gentle radius.

Tk · Post by Tk » Thu Jan 17, 2008 5:35 pm

i may be intrested in a bit big enough for a din size possibly for a gauge holder as i have a blank there at the moment, should have thought about this before last nights meet :?
dont suppose your going to snetterton this sunday are you ?

duncan · Post by **duncan** » Thu Jan 17, 2008 5:38 pm

Tk wrote:i may be intrested in a bit big enough for a din size possibly for a gauge holder as i have a blank there at the moment, should have thought about this before last nights meet :?
dont suppose your going to snetterton this sunday are you ?

shame - i had some with me last night probably the right size for that. Single DIN you say?

Tk · Post by Tk » Thu Jan 17, 2008 5:49 pm

yes single din , sods law that

duncan · Post by **duncan** » Thu Jan 17, 2008 6:07 pm

actually just grabbed the bits i had with me and they are all just under single din sized. I can cut some off the main sheet for you if you can give me exact sizing?