Bigpower

Posted: **Thu May 08, 2008 12:14 pm**

Had a little fiddle about with this this morning.

Just a dummy run so i can get everything sitting right, cut the relevant areas etc, get the spare bumper cut and then get it all painted.

To say this thing is rather large is a little understatement and it looks like it will take 10bar lol

Sorry for the fone pics, but thought the weather was too nice not to take a few.

Posted: **Thu May 08, 2008 12:35 pm**

which hole does your induction kit go in frayz?

Posted: **Thu May 08, 2008 12:37 pm**

Its not a problem Dunc as i have a brand new APS 70mm waiting to go on too.

Posted: **Thu May 08, 2008 12:46 pm**

:thumb:

Make sure you mount the hoses onto the bottom fitting of the fmic left hand side as far on as you can so that they dont push the CAI onto the wheel arch liner. It can cause it to rub against the wheel.

I used an extra 100mm length of silicone to space the CAI filter down into the arch a bit more to give it more room. There may be no problem on yours but worth checking.

Posted: **Thu May 08, 2008 12:55 pm**

Cheers for the tip buddy, any advise is always appreciated.

I have spare hose if need be.

Posted: **Thu May 08, 2008 8:30 pm**

frayz wrote:Cheers for the tip buddy, any advise is always appreciated.

I have spare hose if need be.

looking good..... now build that bloody engine!!!!

Posted: **Thu May 08, 2008 9:53 pm**

Patience my dear boy...

:-D

Posted: **Fri May 09, 2008 6:33 am**

mike-payne wrote:
frayz wrote:Cheers for the tip buddy, any advise is always appreciated.

I have spare hose if need be.
looking good..... now build that bloody engine!!!!

:lol:

Posted: **Fri May 09, 2008 6:48 am**

I could swear your car is grinning!!

Nice one :thumb:

Posted: **Fri May 09, 2008 6:51 am**

frayz - did you weigh the std bumper bar on yours?

Bigpower

Now she looks like a drift racer, ha ha ha

Now she looks like a drift racer, ha ha ha