Bigpower

Looking to make a few changes to how the exhaust back box exits my car. Is there anyone here that can supply 3 inch ID piping so that I can get my back box exit re-routed by chaning the pipe angles.

And ... anyone that can do the work ?

Not looking to get it done til January when the other changes are made nor am i looking for a new backbox (just for mine to be altered)

Cheers

Sounds like a job for me Duncan.
Stainless pipework is normally measured od. I have 76.5mm in stock normally.
Eddy

Cool - sounds like a plan. Looking to move the exhaust up so that the exit comes out at bumper level (through the bumper)

Will chat nearer the time. :thumb:

I can recommend Eddy for this sort of work as he did a good job on matching my 2.5" backbox to my 3" system and did the welding. :thumb:

Thanks again for the praise Francis,
All in a days work.
Eddy