Page 1 of 1
Gareth's Induction Shield Request
Posted: Sun Jun 17, 2007 7:41 am
by RX7
Let me know if you are able to get some Dunk as I am after some for induction shielding.
Posted: Sun Jun 17, 2007 3:36 pm
by RX7
I will get my measurements drawn up and put through a request to you Fast Eddy. Gonna be a while yet though.
Cheers
Posted: Sun Jun 17, 2007 9:11 pm
by Fast Eddy
No worries Gareth,
I make my own range of universal heat sheilds for K&N type filters and make specials too, but if you just want material that is fine. I keep a stock of blanks that may do the job anyway.
Eddy
Posted: Sun Jun 17, 2007 9:59 pm
by RX7
Fast Eddy wrote:No worries Gareth,
I make my own range of universal heat sheilds for K&N type filters and make specials too, but if you just want material that is fine. I keep a stock of blanks that may do the job anyway.
Eddy
I have the HKS RS induction kit with the 2 cones, what I am after is firstly a piece of alu to block the radiator situated directly below the cones and then maybe some shielding from the back of the induction pipes.
But good to know, I will get the measurements made up....they have to fit with the vented bonnet I am putting on shortly you see.
Posted: Mon Jun 18, 2007 5:48 am
by duncan
Split away into its own thread
