Bigpower

Posted: **Wed Sep 13, 2006 2:37 pm**

Seeing as there seem to be a few Subaru owners on here...

My next door neighbour has a new Impreza STI and he's asked if I can give him a hand fitting Defi oil pressure and temp gauges. Should be pretty straight forward fitting the sensors using a sandwich plate between the block and oil filter and putting the gauges in a pod on top of the dash, but where's the best place to run the wires through the bulkhead?

Cheers,

Ben

Posted: **Wed Sep 13, 2006 3:01 pm**

Send Scoobyandscrappy a PM, he's just fitted DEFI's to his Impreza

Posted: **Mon Sep 18, 2006 4:57 pm**

My friend out here has 5 defi's in his scoob. He says its pretty strait forward. You shouldnt have any trouble

Posted: **Mon Sep 18, 2006 6:36 pm**

Should be fine to find any rubber grommet and either make a small slit in that and feed the wires through or make a new hole and use a rubber grommet to feed them through.
Scoob owners will know may specifically though.

Bigpower

Oil temp/pressure gauges on Impreza STI?

Oil temp/pressure gauges on Impreza STI?