Bigpower

Hi

im looking for a decent elbow for a evo fq 340 mr
and a good exhaust system,

anyone point me in the right direction ?

When you say 'good' Billy, do you need it to fit any particular requirements?
-Trackday noise limits?
-Legality for road use?
-Cost?
We have suppliers that can do custom stuff, or there are several decent aftermarket specialists. I know Gary @ APT has done a lot of experiments and testing with flow rates and noise levels on high end performance stuff so if you need something sourced I would start there; equally I know Fast Eddy has fabrication facilities at his place in Norwich if you want something built.

Hope that helps.

Miltek all the way. Have a word with Gary@APT he'll sort you out he's an Evo specialist. My FQ320 MR made 381 bhp and 375 lbft of torque with just an exhaust, fuel pump, plugs and an ecutek remap.

im not after any particular requirements just want something which is good for the value?

Again, Milltek....

or if you want 2nd hand I have an HKS Legamax which is in very good nick. It is cat back. 4" tailpipe.

just brought a nur spec, looking for a 3' downpipe

I put a blitz down pipe on my 6 with a nur spec cat back it will be very loud!!
you might struggle to get on track without the bung.

im not going to be using it for the track,it only get used weekends