Page 1 of 1

anyone know if tsw venoms will clear my ap's

Posted: Mon Jul 06, 2009 9:20 pm
by garetgax
A fellow mids scoobs member has offered me some 7 x 17" tsw venoms for my spare wheels anyone know if they will clear my ap's?

Posted: Tue Jul 07, 2009 5:10 am
by warboys
Depends on what AP's you have fitted and what offset the wheels are. Not enough information to give you an answer.

Posted: Tue Jul 07, 2009 6:31 am
by blacky
I would hope for your sakes they don't :!:

Posted: Tue Jul 07, 2009 11:18 pm
by garetgax
logan they would only be for my track wheels which are going to be black and kawak green to match the graphics going on the car so wont look in the slightest bit chavy by the time we are done but its only if they fit.

Its a case of getting my hands on whatever wheel design alloys that'll fit and dont cost me much as the 888's willset me back just short of 500 notes so beggars can be choosers

Posted: Wed Jul 08, 2009 6:10 am
by blacky
Fair enough mate....didn't think they were for cruizin anyways :wink:

Did you get the slam panel okay?

Posted: Wed Jul 08, 2009 8:09 pm
by garetgax
its sat in the post office mate ready for collection.Mrs is collecting it tomorrow. :D . Big fly in the ointment with the 888's is i need to fit a sump baffle and have been told by TSL its an engine out job to remove the sump which means mucho dosh and therefore a rethink as whilst I would like to run 888's it aint worth at this point the expense for the 888's and the sump. :x

Posted: Thu Jul 09, 2009 9:06 am
by stockcar
you can just about sort the sump without removing the engine you simply lift it off the mounts to gainn access and on occassion you need to drop the s/frame slightly.................