Page 1 of 1

Ally Sheet - how thick ?

Posted: Sun Jun 15, 2008 12:16 pm
by duncan
do I need it to make a small extraction box around my oil cooler.

I am thinking 1mm should be enough ....

Posted: Sun Jun 15, 2008 12:23 pm
by Nige
yeah, should be plenty.

Posted: Sun Jun 15, 2008 2:08 pm
by Fast Eddy
That will be fine Duncan as it is not supporting anything is it.
I have some sheet in stock if you have no local supplier.
Eddy

Posted: Sun Jun 15, 2008 2:11 pm
by duncan
Thanks Eddy, but going to pop in to Metalfast and see what offcuts they have.

Posted: Sun Jun 15, 2008 2:16 pm
by mattie170
What size/how much do you need?

Matt

Posted: Mon Jun 16, 2008 4:50 am
by duncan
I think around 1000mm by 500mm would be plenty

Posted: Mon Jun 16, 2008 7:02 am
by ScoobieWRX
That's a nice size for an Ally undertray :D

Posted: Mon Jun 16, 2008 7:07 am
by duncan
Not even close to being big enough for an undertray. Have you measured the width of your car ?

I am banking on a few left over bits for other projects :D

Posted: Mon Jun 16, 2008 7:18 am
by ScoobieWRX
Not lately...besides i haven't got a ruler big enough :lol: