Page 1 of 1

indicators not working

Posted: Sun May 25, 2008 8:30 pm
by duncan
its not the fuse I have checked that :D anyone got any other ideas and how to locate the issue?

anyone know where the relay is?

Posted: Sun May 25, 2008 9:17 pm
by IWANT1
Should i bring a multimeter :lol:

Posted: Sun May 25, 2008 9:46 pm
by duncan
IWANT1 wrote:Should i bring a multimeter :lol:
erm - it might come in handy :D

Cheers mate :thumb:

Posted: Sun May 25, 2008 10:38 pm
by ScoobieWRX
The relay is under the dash in the same vicinity as the clutch and brake switches just above the pedals. Look above the Clutch/Brake pedal you should see a black connector which has the Turn & Hazard light Module (Relay) plugged into it.

It's a pity the indicators aren't working, you could hear it clicking away then to locate it easily. Have you tried the Hazard switch so all indicators come on and off as it's all on the same circuit.

See pic below - connector B32 is the connector you're looking for in the grayed out box. The illustration is form a left hand drive STi so you should be able to work it out from there.

Image

Posted: Sun May 25, 2008 10:46 pm
by frayz
Dunc, MAKE SURE THE MULTIPLUG HASNT COME OUT OF THE HAZZARD WARNING SWITCH. THE INDICATORS WILL NOT WORK IF THIS HAS BEEN UNPLUGGED.
Whoops sorry for the capps

Posted: Mon May 26, 2008 6:40 am
by duncan
Cheers chaps - will try it out.

Hazards dont work either (nor the remote locking flashing of the indicators)

Posted: Mon May 26, 2008 8:06 am
by duncan
Sorted.

No idea how I did it but the indicators just starting working again :D

The fuse for the hazards had blown though :lol:

Bloody oil :pmsl:

Posted: Mon May 26, 2008 8:08 am
by ScoobieWRX
I bet you're glad now you didn't have to fiddle around under the dash :D

Nothing worse than wiring..... :lol:

Posted: Mon May 26, 2008 8:09 am
by duncan
I hate wiring :D






and oil :D

Apart from that, this whole car tuning thing is easy peezy :lol: