Bigpower

just a quick report on a RR day i attended with the GTIR forums. Car had originally made 358.4bhp and 331lbft at 1.2Bar on EA's rollers back in sept 06 and the only change to my car had been a custom elbow and downpipe.

Ambient Temp was prob around 18deg C and my car was first up.

Figures were 379.4bhp and 318lbft at 1.35Bar but the peak power was made a further 400rpm higher up. Bearing in mind that im still running standard internals and the stock maf thats not bad goin although the MAF is now right on the limit at this point so debating whether to fit the Z32 and go for 400bhp or leave the stock maf in knowing that the engines healthy in current conditions.

dyno sheet will be put up once scanned and video is attached of the first run

Nice power figures 8)

Any ideas on why the torque was down even though the boost was higher?

dynamix wrote:Nice power figures 8)

Any ideas on why the torque was down even though the boost was higher?

I know Zak always says that EA's torque figures are always low, but BHP is pretty accurate. Thats compared to his delta dsah figures.

dynamix wrote:Nice power figures 8)

Any ideas on why the torque was down even though the boost was higher?

i would imagine the torque figure is a bit lower due to the new free flowing elbow and downpipe as opposed to the restrictive stock elbow that was on there when first mapped.

good run there

but the question is........................
...






















































what is going on in this pic??

hahah :lol: i think he is a standby fireman at sizewell. did you get it off his facebook???

:lol: cant believe it.

na got it from the link that his vit at the top was on photobucket or something


security = fail

:-D nice work fella .... you need to be very careful with photobucket

or this one ...

Now quickly clearing out mine