Evo geometry

blacky · Post by **blacky** » Mon Mar 08, 2010 5:41 pm

Gerry, on the Install manual for the Teins it says circa 340mm from wheel centre to arch.

Have search on the Tein UK website and download the superstreet manual as that will tell you, I would assume the heights should be similar for your BC's as the actual geometry of the struts should be the same.

I have print outs at home of my settings as well if required?

Shendy - seen your car on the ramps Saturday, doesn't look too far off now....been a while eh!

shendy · Post by **shendy** » Mon Mar 08, 2010 5:47 pm

A WHILE!!!! bit of an understatment... very close now tho

blacky · Post by **blacky** » Mon Mar 08, 2010 5:49 pm

shendy wrote:A WHILE!!!! bit of an understatment... very close now tho

Yes...Christian was telling me your tales of despair. Not good!

Gerry/Shendy - what spring rates did you go for on the BC's out of interest?

Tonynos · Post by **Tonynos** » Mon Mar 08, 2010 5:53 pm

Phone AutoTest in Norwich and ask for Dave. He should be able to tell you what all the settings should be.

shendy · Post by **shendy** » Mon Mar 08, 2010 6:00 pm

blacky wrote:Yes...Christian was telling me your tales of despair. Not good!

Gerry/Shendy - what spring rates did you go for on the BC's out of interest?

Mmmmmmmmmmmmmmm been intresting:boxing_smiley:
Ive got no idea what the spring rate is

Gerry H · Post by **Gerry H** » Mon Mar 08, 2010 6:04 pm

Crikey, You lot are being really helpful, thanks.

I'll take a look at the Tein site Logan and the geo settings would be great if poss.

Gerry H · Post by **Gerry H** » Mon Mar 08, 2010 6:44 pm

Panic over thanks to Lee for measuring his heights. Mine are way out atm with low by 20mm or so at the rear and high at the front.

Thanks all. Great co-operation