Exhaust work.

323ian · Post by **323ian** » Fri Dec 29, 2006 7:56 pm

Does anyone know a place to reccomend or can anyone do it for me as to where i can get a silencer taken out of my exhaust system?
I dont really want to take it to powerflow as i have had some bad experiences with them.
It could be a bit awkward as i need the pipe to tie in with the rest of the system and it is 90mm diameter so quite big.

Any ideas?

duncan · Post by **duncan** » Fri Dec 29, 2006 10:59 pm

Rob (Cusco demon) had some custom exhaust work done - might be worth a pm to him. I cant remember the name of the place he used but it is local

Post by **Stuart** » Fri Dec 29, 2006 11:46 pm

LPS Ipswich :thumb: Bigman/Steve runs the workshops I think, send him an email or call them for advice.

frayz · Post by **frayz** » Sat Dec 30, 2006 12:08 am

I dont know where youre based mate but Hayward & Scott here in Essex are VERY good

http://www.haywardandscott.co.uk

Call and speak to Ian

Your location says youre : "In the sh1t".. so that dont help me much

323ian · Post by **323ian** » Sat Dec 30, 2006 10:19 am

Thanks for the help.
Yeah sorry Frayz my location is a bit of a shit description.

I am in the swaffham area of norfolk.

Essex is a bit far to run for the work so will try these local ones.
Cheers.

rowdyburns · Post by **rowdyburns** » Tue Apr 03, 2007 9:30 am

323ian wrote:Does anyone know a place to reccomend or can anyone do it for me as to where i can get a silencer taken out of my exhaust system?
I dont really want to take it to powerflow as i have had some bad experiences with them.
It could be a bit awkward as i need the pipe to tie in with the rest of the system and it is 90mm diameter so quite big.

Any ideas?

90mm! Damn thats 3.5"

Are you running 600 bhp +

If you are really stuck i could roll you a section from sheet and TIG weld it in for you for a few quid?

crash · Post by **crash** » Tue Apr 03, 2007 10:21 am

There is a guy in Holme Hale that does welding and fabrication called Glen Easter, i think he used to be in Necton. he has done some work for me and was very reasonable with the price, i havent got his number im affraid, but can tell you where he is if you are intrested !

323ian · Post by **323ian** » Tue Apr 03, 2007 8:09 pm

Thanks for the advice everyone.
This has been all sorted now, got eddy (fast eddy's) to sort it out for me, did a really good job.
It was 96mm in the end, no wonder she sounds nice!! 8)

Bigpower

Exhaust work.

Exhaust work.

Re: Exhaust work.