Fitted a couple of bits to the car today :)

Nik · Post by **Nik** » Sat Dec 30, 2006 11:58 pm

Well I have been busy today.

I have fitted the brake master cylinder stopper and the grounding kit. Both were pretty easy to fit apart from the fact that when I was fitting the grounding kit I thought I would take the plug off of the water temp sensor to make it easier to get to the grounding point by the fuel pressure regulator. When I went to take the plug off, the bloody sensor snapped off in my hand. However, all was not lost. One quick phone call to my mate at MGT and he just happened to have a spare one at work.

He has just left after bringing it round tonight for me.

So that will be replaced tomorrow and then I can take it for a spin to test it.

I didn't get round to fittng the new boost controller as it started to rain just as I finished the grounding kit.

Another job for tomorrow

(possibly )

I will try and get pics of them tomorrow aswell just to show you the new additions

Nik

frayz · Post by **frayz** » Sun Dec 31, 2006 12:39 am

Good work fella

duncan · Post by **duncan** » Sun Dec 31, 2006 8:57 am

A good day's work

It is always a nighmare when somenthing silly like that happens - you were lucky to find a spare so quickly.

Post by **Ben** » Sun Dec 31, 2006 11:05 am

Get the pics up - I was going to have a go fitting mine but couldn't be arsed

. I'll do it when all my other bits have turned up.

ants13 · Post by **ants13** » Sun Dec 31, 2006 1:17 pm

Cool, I'll have alook after work tuesday!!!

Nik · Post by **Nik** » Sun Dec 31, 2006 2:09 pm

A couple of pics

It runs so much smoother now and the brakes are much better.

ants13 · Post by **ants13** » Sun Dec 31, 2006 3:02 pm

Looks good mate

Bubble · Post by **Bubble** » Mon Jan 01, 2007 10:27 pm

Looking good there Nik 8)

Post by **Ben** » Tue Jan 02, 2007 9:47 am

Nice work fella - looking forward to getting mine fitted