Page 1 of 4

A project i been doing UPDATED Its now running

Posted: Sun Nov 18, 2007 12:07 am
by martin
The car is under going a major change body and Engine spec and though would post the progress so far :D

It started like this

Image

Image

Image

Image


The Engine and interior was removed and of it went to the body shop and has came back like this :D

Image

Image

Image

Image

Image


Next job to be done was to get the front end together and get the intercooler mounted :D

Image

After the bumper had been made to fit Autobahn was sprayed on

Image

Image

The engine has been stripped here is a few bits

Image

Image

The block and heads have been sent of to be altered :wink: And will be back at some point next week and let the engine build commence :D

Had to make the inlet manifold look more attractive so a clean an a lick of high temp paint later :D

Image


I will add to the post as the project goes on :D

cheers
Martin

Posted: Sun Nov 18, 2007 2:27 am
by Bladerider
Nice,

Not the first time a Scooby/Qualcast jokes been made though !!!

:D :D :D

Interesting choice of colour swap when white is currently the colour back in fashion !! best of luck with the project.

J.

Posted: Sun Nov 18, 2007 9:36 am
by Rnash2002
So thats what you have been upto,looking good mate :thumb:

Posted: Sun Nov 18, 2007 9:52 am
by Ben
Looking good, I liked the white better though :)

Posted: Sun Nov 18, 2007 10:02 am
by Tk
have to agree with the white but each to there own , looks like it will keep you busy

Posted: Fri Nov 30, 2007 10:08 pm
by martin
A little update the engine is now coming on nicely :D

Picked up all the bits today to get the ball rolling

The cleaned bored block ready to receive its new internals
Image



The new set of Mahle pistons
Image

A nice set of rods
Image



The heads have been ported and flowed
Image
Image
Image
Image
Image


The flywheel has been lightened and balanced with the clutch assembly
Image


The bearings fitted into the block
Image

Have used the ACL bearings

The crank in place
Image

Fitting rear oil seal
Image


The pistons fitted in the block
Image

The heads are being held in place by ARP head bolts
Image


Fitted one cylinder head
Image


Next is to get the engine on the stand and finish it of :D


Will keep you updated :D

Posted: Fri Nov 30, 2007 10:14 pm
by JP_Tuner
Comming along nicely.

Posted: Fri Nov 30, 2007 11:04 pm
by Gerry H
Nice thread and will watch with interest. Thanks for sharing :thumb:

Posted: Fri Nov 30, 2007 11:16 pm
by ScoobieWRX
I have to say the original colour with black bonnet and rear spoiler made it look like the fastest taxi in the UK :D and i quite like the new colour, it's different.

Pics are great though, and those shots of the ports and valves are a bit of intimate porno if you ask me :devil: but i look forward to next instalments with interest.

Posted: Sat Dec 01, 2007 10:15 pm
by martin
We picked up the Turbo that will be used today

Image

Image

Image

Image

We will see how it goes :D