Mapping on Rolling Road - Any tips for a first timer?

duncan · Post by **duncan** » Wed Nov 15, 2006 9:04 pm

Good luck with the session on the rollers tomorrow Tony

TonyB · Post by **TonyB** » Thu Nov 16, 2006 9:13 pm

Thanks Duncan,

Think I needed a little more luck tho :lol:

I had a great time today. 3 hours on the rollers. It was very slow progress to start with, as I got use to things. I found a nasty misfire at just under 6k rpm - The power was still well on the up at the point - I think this is due to a HT problem that I have to work out, I am hoping it is just the coil dwell setting.

I only had time to map to .9 bar, I was hoping to get closer to 1.4 bar

Soooo, for now I will have to make do with 266bhp and 271lbft :?
Well on track for >350 tho

duncan · Post by **duncan** » Thu Nov 16, 2006 9:17 pm

Glad that progress was made though

Were many adjustments made by Clive or was he leaving it all down to you whilst on there?

DASHughes · Post by **DASHughes** » Thu Nov 16, 2006 9:20 pm

Thats not too shy considering the level of boost its set to. 1.4Bar-your going to love that :twisted:

Glad it worked out for you though(within reason) and the dreaded didn't happen :thumb:

bazzagt4 · Post by **bazzagt4** » Thu Nov 16, 2006 9:58 pm

Still chipping away Tony....well done, bet you cant wait for the final result

.....Fastest 185 at our challenge weekend is in your sights, Im sure 8)

Regards